dave's project is one of our best executions thus far.  dave
needed a race legal vehicle (sub 12-sec) and wanted to keep the
car in somewhat stock form.  he elected to do the following:

dave's set-up features:
- TIG welded KMS-fab 6-point roll bar
- rear down bars to retain rear seats
- KMS-fab custom end-links
- removable harness bars
- KMS-fab OEM tank sump (-10AN)

this project turned out very well.  we had zero issues with this
car and everything went smoothly.  these roll bars and cages do
not come pre-bent, we bend them here for a nice tight custom
fit for every car that enters the shop.  thanks dave!
created by:  b.kordenbrock; 2006
KMS-fab removable
end-links
dave's 1992 VX Hatch:
troy kordenbrock - 513.368.3963 (troy@kms-fab.com)
& brett kordenbrock - 513.205.2706 (brett@kms-fab.com)
rollbar fabrication & installation process - here we
put 3" holes in the floor in order to drop the roll
bar down.  this allows us to weld the very tops of
the rear bars or front bars on an actual rollcage
KMS-fab OEM fuel tank sump - Civic
seam sealed and
primered
coated and ready
for install